Skills, in their native habitat.

This skill should be used when the user asks to "review STM32 code", "check my firmware", "find bugs in embedded code", "validate peripheral initialization", "audit interrupt...

This skill should be used when the user asks to "read application note", "check AN document", "application note guidance", "AN reference design", "ST app note", "AN2606",...

This skill should be used when the user asks to "identify my MCU", "extract board information", "what chip is this", "read the datasheet", "get MCU specifications", "board...

This skill should be used when the user asks about "boot mode", "BOOT0 pin", "BOOT1 pin", "boot from flash", "boot from SRAM", "system memory boot", "debug interface", "SWD",...

This skill should be used when the user asks about "bus architecture", "AHB APB buses", "bus matrix", "DMA channels", "clock tree", "S-Bus", "I-Bus", "D-Bus", "memory...

This skill should be used when the user asks about "flash sectors", "flash pages", "SRAM regions", "SRAM layout", "linker script", "memory map", "CCM RAM", "DTCM ITCM", "backup...

This skill should be used when the user asks to "configure GPIO", "set up UART", "initialize USART", "configure SPI", "set up I2C", "configure ADC", "set up DAC", "configure...

This skill should be used when the user asks about "FreeRTOS on STM32", "RTOS task creation", "task priorities", "stack sizing", "mutex", "semaphore", "queue", "event groups",...

This skill should be used when the user asks about "flash protection", "readout protection", "RDP levels", "secure boot", "TrustZone", "PCROP", "write protection", "firewall",...

Full STM32 development pipeline that chains all 4 agents in sequence. Use this command to run the complete workflow from environment analysis through code review.